Broadband Random Noise Generator Circuit This circuit is normally necessary in testing any sort of electronic methods for example filter, audio, or RF communication. The circuit introduced right here generates an RMS amplitude regulated noise source with selectable bandwidth. This circuit is work depending on op amp. This will be the figure with the circuit. [...]
1000 Volt DC to DC Regulator Circuit Input voltage from high voltage DC DC converter is 12V AC at 800mA current and then converted to DC through a bridge rectifier Diode 1A. The voltage output of converter circuit can be adjusted in the range of 0-1000V DC. This high voltage DC DC converter uses the [...]
Figure 1, below, shows the 10.58 to 10.74 MHz VFO oscillator circuit. Yes, this is the same circuit that was presented last time, but I’ve re-drawn it to show the Colpitts oscillator more clearly. “L” is approximately 1.5 uH; 19 turns in a T50-6 core (yellow). The value of C6 is found experimentally. I used [...]
Output Relay Delay Audio Amplifier Circuit This is a simple circuit which I built to one of my audio amplifier projects to control the speaker output relay. The purpose of this circuit is to control the relay which turns on the speaker output relay in the audio amplifier. The idea of the circuit is wait [...]
This 6V6 amp was built following the push-pull (PP) EL84 / 6V6 Dynaco A-410 output transformer schematic. There are a few minor deviations from the original schematics. Instead of Dynaco transformers, Hammond 1608A audio output transformers and a Hammond 272HX power transformer were used. The EL84 / 6V6 PP Dynaco A-410 output transformer schematic showed [...]
RC5 is not suitable as a barrier to race out to whoever is the winner. Two or more RC5 channel interfere with each other and the protocol itself also takes time for the transfer. If more than one car with RC5 transmitter arrive close together, it can well be the first and the second triggers [...]
The circuit below illustrates two pairs of LEDs that operate out of phase so as one pair slowly illuminate, the other pair will fade. Circuit description: This circuit is used to slowly illuminate and fade a pair of red LEDs (light emitting diodes). The fading LEDs could be installed as ‘eyes’ in a small pumpkin [...]
