12 volt Wind Turbine It is possible to use a 12V DC motor (I assume its a car starter motor) as a wind turbine generator to provide energy conversion between the mechanical torque from the wind rotor turbines, (called the prime mover) and the connected 150V load. A gearless two or three bladed upwind wind [...]
1000 Volt DC to DC Regulator Circuit Input voltage from high voltage DC DC converter is 12V AC at 800mA current and then converted to DC through a bridge rectifier Diode 1A. The voltage output of converter circuit can be adjusted in the range of 0-1000V DC. This high voltage DC DC converter uses the [...]
The stoboscope tube needs about 250-400V DC to operate. This high voltage is generated using simple voltage step up circuit built from transistors Q1,Q2 and transformer T1. This circuit gives out about 230V AC voltage which is then rectified with rectifying bridge U1 (must have at least 400V voltage rating) and stored to the main [...]
This 6V6 amp was built following the push-pull (PP) EL84 / 6V6 Dynaco A-410 output transformer schematic. There are a few minor deviations from the original schematics. Instead of Dynaco transformers, Hammond 1608A audio output transformers and a Hammond 272HX power transformer were used. The EL84 / 6V6 PP Dynaco A-410 output transformer schematic showed [...]
The circuit works much like the original Strobos. except that a fluorescent tube is used. Thus, the fluorescent tube zündbereit remains constant, the two electrodes of the tube are continuously transformer Ta1 supplied with electricity. This current makes the two resistance wires of the glow tube in, so the mercury evaporates into the tube and [...]
Parts R1 27 Ohm 5W Resistor or 27 Ohm 10W Resistor R2 240 Ohm 5W Resistor or 240 Ohm 10W Resistor BR1 50 Volt, 6 Amp Bridge Rectifier C1 8000uf, 35 Volt Capacitor Q1, Q2 2N3055 NPN Power Transistor T1 24V 5A Transformer (See “Notes”) T2 TV Flyback Transformer (See “Notes”) S1 115V 3A SPST [...]
Time Interval Relay Circuit for the clock circuit above This is a programmable clock timer circuit that uses individual LEDs to indicate hours and minutes. 12 LEDs can be arranged in a circle to represent the 12 hours of a clock face and an additional 12 LEDs can be arranged in an outer circle to [...]
